TM 9-2320-365-34-2
13-6. REAR CROSSMEMBER REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Rear tension beam removed (para 13-5).
Rear bumper removed (para 13-8).
Rear spring rear bracket removed (para 13-9).
Rear marker lights removed (TM 9-2320-365-
20-3).
Rear gladhands removed (TM 9-2320-365-20-
3).
Rear intervehicular 12 VDC (7 Pin) cable
removed (TM 9-2320-365-20-3).
Rear intervehicular 24 VDC (12 Pin) cable
removed (TM 9-2320-365-20-3).
Tools and Special Tools
Tool Kit, Genl Mech (Item 68, Appendix B)
Wrench, Torque, 0-600 lb-ft (Item 85, Appendix B)
Wrench Set, Socket (Item 74, Appendix B)
Goggles, Industrial (Item 25, Appendix B)
Socket, Socket Wrench (TM 9-2320-365-20)
Materials/Parts
Pin, Cotter (Item 230, Appendix F)
Nut, Self-locking (16) (Item 134, Appendix F)
Bolt (2) (Item 6, Appendix F)
Bolt (10) (Item 10, Appendix F)
Grease, Automotive and Artillery (GAA) (Item 36,
Appendix C)
Personnel Required
(2)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris.
Failure to
comply may result in injury to personnel.
a. Removal.
(1) Remove cotter pin (1) from nut (2). Discard cotter pin.
(2) Remove nut (2) and washer (3) from pintle hook (4).
(3) Remove pintle hook (4) from rear crossmember (5).
(4) Remove four self-locking nuts (6), screws (7), and
support (8) from rear crossmember (5). Discard self-
locking nuts.
Change 1
13-13
