TM 9-2320-365-34-2
(3) Position bolt (4) and self-locking nut (5) in rear
crossmember (1).
(4) Tighten self-locking nut (5) to 210-225 lb-ft (285-305
N·m).
(5) Perform steps (1) through (4) on right side of rear
crossmember.
(6) Position support (6) on rear crossmember (1) with four
screws (7) and self-locking nuts (8).
(7) Tighten four self-locking nuts (8) to 195-239 lb-ft (265-
325 N·m).
(7.1) Apply coat of grease to shaft of pintle hook (9).
(8) Install pintle hook (9) in rear crossmember (1) with
washer (10) and nut (11).
CAUTION
Clearance between washer and support must
be 0.003-0.017 in. (0.07-0.43 mm). Failure to
comply may result in damage to equipment.
(9) Adjust nut (11) until clearance is 0.003-0.017 in. (0.07-
0.43 mm) with alignment holes lined up between nut and
pintle hook (9).
(10) Install cotter pin (12) in nut (11).
Change 1
13-15
