TM 9-2320-365-34-216-2. 11K SELF-RECOVERY WINCH (SRW) ASSEMBLY REPLACEMENT/REPAIR(CONT)(35) Remove two spring pins (58), roller shafts (59), andcable guide sheaves (60) from base mounts (19).Discard spring pins.(36) Remove two bushings (61) from cable guide sheaves(60).c. Cleaning/ Inspection.WARNING•Dry Cleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles andgloves; use only in well ventilated area; avoid contact with skin, eyes, and clothes, and donot breathe vapors. Keep away from heat or flame. Never smoke when using solvent; theflashpoint for Type I Dry Cleaning Solvent is 100°F (38°C) and for Type II is 130°F (50°C).Failure to comply may result in serious injury or death to personnel.•If personnel become dizzy while using cleaning solvent, immediately get fresh air andmedical help. If dry cleaning solvent contacts skin or clothes, flush with cold water. If drycleaning solvent contacts eyes, immediately flush eyes with water and get immediate medicalattention. Failure to comply may result in serious injury or death to personnel.• Compressed air used for cleaning purposes will not exceed 30 psi (207 kPa). Use only witheffective chip guarding and personal protective equipment (goggles/shield, gloves, etc).Failure to comply may result in injury to personnel.NOTEReplace any part that fails to pass visual inspection or size measurement requirements.(1) Clean all metal parts with dry cleaning solvent.16-8
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business