TM 9-2320-365-34-2
16-6. POWER TAKE-OFF (PTO) REPLACEMENT/REPAIR (CONT)
WARNING
Use care when removing retaining rings.
Retaining rings are under tension and can
act as projectiles when released. Failure
to comply may result in injury to
personnel.
(5) Remove retaining ring (7) from bearing cap (2).
(6) Remove output shaft (8) from bearing cap (2).
(7) Remove retaining ring (9) and bearing (10) from bearing
cap (2).
(8) Remove spacer (11) from output shaft (8).
(9) Remove retaining ring (12) from output shaft (8).
(10) Remove clutch back-up cylinder (13), vee ring (14), and
piston (15) from output shaft (8).
NOTE
Perform step (11) on PTO Assembly (P/N
276XMF-JX-D5XK).
(11) Remove key (16) from output shaft (8).
(12) Remove spring (17) from output shaft (8).
(13) Remove two preformed packings (18) from output shaft
(8). Discard preformed packings.
(14) Remove seven clutch plates (19) and eight friction plates
(20) from output shaft (8).
16-30
Change 1
