TM 9-2320-365-34-2
(14) Disconnect connector (27) from connector P56 (28).
(15) Remove nut (29), lockwasher (30), and terminal lug TL31
(31) from base (26).
(16) Disconnect connector (32) from connector P54 (33).
(17) Remove nut (34), lockwasher (35), and terminal lug TL30
(36) from base (26).
NOTE
Use bolts P/N 12414307-143 and self-locking
nuts P/N 12414308-025 on step (18).
Step (18) requires the aid of an assistant.
(18) Install pintle hook extension (37) on rear crossmember
(9) with two bolts (38) and self-locking nuts (39).
(19) Match mark four top holes (40) on rear crossmember (9).
(20) Remove two self-locking nuts (39), bolts (38), and pintle
hook extension (37) from rear crossmember (9).
(21) Drill four 0.375 in. (9.5 mm) pilot holes in rear
crossmember (9) at matchmarks.
(22) Drill four 0.75 in. (19 mm) holes in rear crossmember (9).
Change 1
18-5